Putting “Noiseless“ Pickups In My 2004 Fender American Standard Stratocaster

Putting “Noiseless“ Pickups In My 2004 Fender American Standard Stratocaster Get 5 boards in about a week for $27! In this video I replace the OEM Fender single coil pickups in my 2004 American Standard Stratocaster with “Fender Hot Noiseless“ pickups. Single coil pickups tend to pick up 60Hz hum from the mains. In the late 1950’s Gibson invented the “humbucker“ pickup. It is two single coils side by side wired out of phase. It not only cancels the hum, but it gives the guitar a thick heavy voice. Fender Noiseless pickups are basically a stacked humbucker design, the two coils are placed vertically. This gives you the hum cancelling of the humbucker, but keeps the bell like chimey tones of the original Stratocaster pickups. ************************************************************************* *Please help support this channel at NO COST TO YOU. If you shop on* *Amazon, please use this link: * *I will get a small commission and it costs you nothing. * ************************************************************************* HEY YOU ABOUT TO POST SOMETHING STUPID: Yes, I know my hands are large/fat. It’s because of a heart condition I suffer from called Congestive Heart Failure. Here’s a link to some information about CHF: One of the symptoms is that it causes fluid retention, mostly in the hands, feet/ankles, and face.. ------------------------------------------------------------------------------------------------------------------- Support learnelectronics: Amazon Store: If you are shopping for electronic components, test gear or consumables please consider visiting my Amazon shop @ Patreon: Please check out and pledge a dollar if you can. It will go a long way to keeping the channel alive. It costs a bit of money to buy all the items and produce these videos. Your help is appreciated. Paypal: you’d like to send a one-time donation you can use this link: --------------------------------------------------------------------------------------------------------------------- Gear I use: Multimeter: OWON B33 Oscilloscope: KIPRIM DS1202 Signal generator: Junctek JDS8080 Component Tester: T7 Multifunction Soldering Station: Sealody ???????