Dragonfly print-in-place articulated print on ender

Insect The third, King of the Sky dragonfly was designed. STL download link - I tried to express the curve of the entire body and the beautiful and transparent dragonfly wings, and I went through a lot of trial and error. At first, I tried to express the wings by laminating the first layer with a thin film, but it was not as neat as I thought, and there was a problem that it was difficult to peel off the bed. So, I changed the design by drawing only the wing pattern, and I think it has a better shape. As the number of lines increased, the difficulty of printing increased. The position of the wings can be fixed so you can pose with the wings from several different angles. As the legs are connected at once, it will not be difficult to assemble if you fold them a few times and then insert them. This can be a little confusing, but if you refer to the video, it will be easy. The connection between the body and the belly (tail) must be turned over 180 degrees. thank you Largest part in printing, size = X 197mm, Y 123mm, Z 15mm