Self-locking stainless steel cable holders manufactured by CARBOMECH Ltd

Self-locking stainless steel cable holders manufactured by CARBOMECH Ltd Holders for mounting on brackets, the hook is screwed to the bracket, both elements of the Holder are connected by a steel cable. Self-locking stainless steel cable holders : 3-201.L ÷ 3-212.L manufactured by CARBOMECH Ltd The holders are attached directly to the brickwork in the shaft, both elements of the Holder are connected by a steel cable. For all cable variants, the dimensions of the part, i.e. the fixed jaw and the movable jaw are the same. Holder type: 3-201 for cables with an outer diameter of 10-13 mm 3-202 for cables with an outer diameter of 14-17 mm 3-203 for cables with an outer diameter of 18-21 mm 3-204 for cables with an outer diameter of 22-27 mm 3-205 for cables with an outer diameter of 28÷33 mm 3-206 for cables with an outer diameter of 34-39 mm 3-207 for cables with an outer diameter of 40-47 mm 3-208 for cables with an outer diameter of 48÷55 mm 3-209 for cables with an outer diameter of 56÷63 mm 3-210 for cables with an outer diameter of 64÷73 mm 3-211 for cables with an outer diameter of 74÷83 mm 3-212 for cables with an outer diameter of 84÷94 mm Each cable holder (of this type) is made exactly according to the average outer diameter of the cable, installed in the shaft, with an accuracy of 1 mm, set by the shaft. The bracket design ensures that the cable is held within the deviation of the cable dimensions. A prerequisite for the proper operation of the self-locking chuck is: the correct selection of the bracket for the cable diameter, the correct location of the cable clamping jaws, Pre-connect the holder to the cable by hitting the protruding part of the movable part with a hammer. The initial clamping of the cable in the cartridge must be achieved by hitting a movable sponge with a hammer weighing 500 g. This will set the moving part in motion, jam the cable in the chuck and create a friction clutch between the handle and the uncontrolled impact on a movable sponge (for example, with great force) will lead to the loss of the self-tightening properties of the cable! The worker inserting the cable into the holder relies only on feeling whether one blow is enough or whether it needs to be repeated. The force must be high enough for the cartridge to start working as a self-locking one. If the force is too low, the cable will move in the holder without clamping the clamp under load. The principle of operation of the holder is based on a friction connection, which is due to the automatic pressing of a fixed and movable sponge against the cable when force is applied from the mass of the cable hanging under the handle. The self-locking cable holder mounted on the bracket consists of a cable part and a mounting part, which are connected by a steel cable. CARBOMECH Ltd has been a reliable business partner from Poland for over 30 years! Our website: Technical consultation. Tel./WhatsApp: (48)733-275-085 CARBOMECH Ltd Marketing Department Sviatoslav Makieiev Email Personal: carbomech@ Corporate email: @