3D Printed worm drive powered by stepper motor
It’s just a prototype for a project that I’m currently working on. All parts were 3D Printed (except metal shafts and bearing). Print time for all parts was about 15 hours total.
Printer used: Creality CR 10S
Software used: SolidWorks, Cura
Worm and worm gear in Solidworks tutorial:
10 years ago 00:02:16 120
2 years ago 00:03:08 40
9 years ago 00:10:37 4.8K
9 years ago 00:05:35 99
4 years ago 00:08:44 18
8 years ago 00:03:22 130
12 years ago 00:06:16 62
4 years ago 00:09:00 65
11 years ago 00:03:58 72
12 years ago 00:03:50 110
5 years ago 00:02:35 76
12 years ago 00:24:10 340
4 years ago 00:08:24 9
5 years ago 00:10:50 42
10 years ago 00:04:06 24
5 years ago 00:07:14 60
3 years ago 00:28:18 74
6 years ago 00:02:05 128
7 years ago 00:04:29 139
6 years ago 00:02:20 59
9 years ago 00:02:42 120
10 years ago 00:03:09 24
6 years ago 00:07:49 38
4 years ago 00:08:25 48
