Increasing the Torque of my PCB Motor

Оригинал видео: Все права на это видео принадлежат автору канала: So torque is the biggest weakness of my tiny PCB motor. This was measured it to be it is something that can be improved. These are three ways how I tried to improve it: Double Rotor - Some people in the comments suggested to try and use a double rotor. This will increase the magnetic field produced by the neodymium magnets and therefore will also increase the motor’s torque. But in practice this was not the case and it barely had any effect. The measured torque was (the same as with one rotor). Ferrite Sheet - This was used as a core to increase the strength of the magnetic field inside the printed windings. Two different shaped cores were tested. The uncut one gave a higher torque value and has increased it from to . The only down side of this is that It has also increased the pcb’s temperature from 70°C to 90°C due to eddy current losses. Delta configuration - Other simple way to increase the torque is by changing the configuration to a delta winding. This way the coils will be powered with a higher voltage, so it will also increases the torque and temperature (hopefully not by much). This approach was not tested yet. Follow me on Twitter: Open Source files: