Darth Maul TMP custom saber install

Recent saber install I did for a customer with a KR/OR “Revenge“ empty hilt, custom 3D-printed dual chassis and top saber pixel electronics with dual Proffieboard v2.2 sound boards setup. Features: • easy and completely removable chassis system • 28mm bass speakers • all 4 buttons can be functional or only specific buttons on each side • dual Proffieboard v2.2 sound board setup for 2 blades • BT909 bluetooth module for remote control • dual removable Protected 18650 batteries in parallel configuration for double run time (2 hours of average run time instead of 1 hour in most neopixel sabers) • RGB pixel side accent leds • SCW NPXL connector for the blade • Kill Switch • USB-C port for batteries charging, board firmware upgrades and SD card access • TC4056 Li-Ion 1A battery charging module My website: My Shapeways 3D-printed chassis store: Facebook: